arrowFree Inspection

Sump Pump Installation in Your Maryland Home – A DIY Project?

If you’re looking for information about sump pump installation for your Maryland home, then you already know that sump pumps are important for keeping your basement dry. Sump pumps work to move any accumulated basement water caused by run-off or ground water saturation. Sump pump installation in your Maryland home may look like an easy Do-It-Yourself (DIY project), but in reality it’s not. Doing a sump pump installation in your Maryland home by yourself can be dangerous, and should only be performed by professionals, like those at Basement Waterproofing Nationwide (BWN).

Sump pump installation involves both electrical and plumbing work. Professionals determine the best place in a basement to install the sump pump, and where the discharge pipe will run out of the basement. Then they will place a sump pump liner and jackhammer the concrete to dig a hole for the sump pump installation in your Maryland home.

After the sump pump hole is dug, the liner is put in place and sealed. The discharge pipe is attached to the sump pump, and run outside of the house. Professionals must support, caulk, and seal the discharge pipe, adjust the sump pump, plug in the pump, and check its operation. Electricity and water is a dangerous combination, so sump pump installation in your Maryland home should only be done by qualified professionals, like BWN.

Sump pump installation in your Maryland home is best left to the professionals. Save your time, money, and energy, and contact BWN today. Contact BWN today online or call 1-(888) 430-6587.

Basement Waterproofing Nationwide